Rockwell Automation 1771-OP Protected AC (120V) Output Module Installation Instructions - Manual (Page 7)

Protected AC Output Module 7
Publication 1771-IN077A-EN-P - October 2002
1. Make certain all power is removed from the module before
making wiring connections.
2. Swing the wiring arm up into position on the front of the module.
The locking tab on the module will secure it into place.
3. Make your connections to the field wiring arm as shown in
Figure 1. (Use the label on the front of the wiring arm to identify
your wiring.)
IMPORTANT
The field wiring arm terminal identification
number is not the same as the number of the bit
which controls that output.
You should identify the labels on the wiring arm with the name or
number of the device connected at each terminal.
Figure 1
Connection Diagram for the 1771ĆOP Protected Output Module
A
O
1
2
3
4
5
6
7
B L2
L2
ac Low
L1
120V ac High
ac Device
controlled by termiĆ
nal
L1
(Actual wiring runs in this direction.)
11884-I
Output 03
Output 02
Output 01
Output 00
Not used
Not used
Not used
Not used
Connect the high side of incoming power to the L1 terminal, and the
low side to the L2 terminal.
ATTENTION
!
Paralleling outputs may result in damage to the
module.