Rockwell Automation 1771-OBD Series C INSTL INSTR DC(10-60V) OUTPUT - Manual (Page 6)

6 dc (10…60V) Output Module
Publication 1771-IN054C-EN-P - November 2006
Install the Module
Install the module and secure it in the chassis.
1. Position the module in the card guides
for the chosen slot.
2. Slide the module into the chassis and
apply firm, even pressure to seat the
module into its backplane connector.
3. Series A chassis: Snap the chassis latch
lever over the top of the module to secure
the module in the chassis.
Series B chassis: Swing the locking bar
down into place, making sure the locking
bar pins are engaged to secure the module
in the chassis.
4. Attach the field wiring arm to the
horizonal bar at the bottom of the
chassisThe wiring arm pivots upward so
you can install or remove the module
without disconnecting the wires.
The 1771-OBD module is a modular component
of the 1771 I/O system requiring a properly
installed system chassis. Refer to the Universal
I/O Chassis Installation Instructions, publication
1771-IN075, for detailed information on.
acceptable chassis, along with proper installation
and grounding requirements. Limit the adjacent
slot power dissipation to 10 W maximum.
ATTENTION
Make certain that you do not install this module into a chassis slot keyed for a 1771-IAD
series D input module.
1771-A1B, 1771-A2B, 1771-A3B,
1771-A3B1, 1771-A4B I/O Chassis
Locking Tab
Card Guides
Module
1771-A1B, 1771-A2B, 1771-A3B1,
1771-A4B Series B I/O Chassis
Module
Card Guides
Locking Bar
Locking Bar Pin
Wiring Arm
Install
Remove
Horizontal Bar
1771-WH