Rockwell Automation 1792D-4BVT4D ArmorBlock MaXum 4 Input/4 Output Module Series B - Manual (Page 7)

ArmorBlock MaXum 4 Input / 4 Output Module Series B 7
Publication 1792D-IN012B-EN-P - September 2000
I/O connectors for this module are shown below.
Output Power and DeviceNet Cables
Output power and DeviceNet cables are described in the installation
publications for the cable base assembly of your choice. Refer to the
following publications:
• 1792D-IN009B-EN-P ArmorBlock MaXum Cable Base
Installation Guide
• DN-6.7.2 DeviceNet Cable Planning and Installation Manual
ATTENTION
!
• Make sure all connectors and caps are
securely tightened to properly seal the
connections against leaks and maintain IP67
requirements.
• For maximum noise immunity, input and
output cable return wires must be properly
terminated. When inputs and outputs are
connected in loopback, return wires should
be connected together.
• I/O cable length should be less than 30
meters.
I0
I1
I2
I3
O0
O1
O2
O3
Auxiliary Power
Logic Status Net/Mod Status
Output 0
Output 1 Input 0
30706-M
Input 1
Input 2
Input 3
Output 2
Output 3
Connector A
Connector B
Connector C
Connector D