Rockwell Automation 1788-DNBO DeviceNet Daughtercard Installation Instructions - Manual (Page 6)

6 DeviceNet Daughtercard
Publication 1788-IN053A-EN-P - December 2001
Set the Network Baud Rate
You must set one switch to configure the network baud rate. Figure 1 shows the location of
the switch. The switch is read on power-up.
Set the switch to a value between 0 and 2, according to this table:
Install the Daughtercard
Due to wide variation in available host devices, we cannot provide specific installation
instructions in this document. For instructions on how to install the daughtercard in a host
device, refer to the user manual for the particular host device.
Switch Setting Baud Rate
0 125Kb
1 250Kb
2 500Kb
IMPORTANT
Do not install or remove the daughtercard while the host is under power.
WARNING
!
Inserting or removing the module while host power is on may cause an
electrical arc. This could cause an explosion in hazardous location in-
stallations. Be sure that power is removed or the area is nonhazardous
before proceeding.