Rockwell Automation 1788-DNBO DeviceNet Daughtercard Installation Instructions - Manual (Page 7)

DeviceNet Daughtercard 7
Publication 1788-IN053A-EN-P - December 2001
Connect the Card to the Network
After you have installed the daughtercard, you can connect it to the network.
1. Connect the DeviceNet drop line to the 5-pin DeviceNet connector provided with
the card. Match the wire insulation colors to the colors shown on the label.
2. Attach the connector to the DeviceNet port on the daughtercard.
3. Tighten the connector screws.
WARNING
!
If you insert or remove the card while host power is on OR
if you connect or disconnect the DeviceNet cable with power applied
to this module or any device on the network, an electrical arc can
occur.
Either could cause an explosion in hazardous location installations.
Be sure that power is removed or the area is nonhazardous before
proceeding.
Pin Number Wire Color Symbol Description
1 Black V- 24V dc Power Return
2 Blue CAN_L Data Low - Data Line
3 Bare DRAIN Shield
4 White CAN_H Data High - Data Line
5 Red V+ +24V dc
Red
White
Bare
Blue
Black
31292-M