Rockwell Automation 1788-ENBT EtherNet/IP Daughtercard Installation Instructions - Manual (Page 5)

EtherNet/IP Daughtercard 5
Publication 1788-IN054A-EN-P - September 2002
Install the Daughtercard
Due to wide variation in available host devices, we cannot provide specific installation
instructions in this document. For instructions on how to install the daughtercard in a
host device, refer to the user manual for the particular host device.
Connect the Daughtercard to the Network
After you have installed the daughtercard, you can connect it to the network
via the RJ45 connector.
IMPORTANT
Do not insert or remove the daughtercard while the host is under
power. The daughtercard is not designed to be inserted or
removed while the host is powered.
WARNING
!
Inserting or removing the module while host power is on may
cause an electrical arc. This could cause an explosion in haz-
ardous location installations.
WARNING
!
If you insert or remove the card while host power is on OR
if you connect or disconnect the Ethernet cable with power
applied to this module or any device on the network, an
electrical arc can occur.
Either could cause an explosion in hazardous location
installations.
Be sure that power is removed or the area is nonhazardous
before proceeding.