Rockwell Automation 1788-ENBT EtherNet/IP Daughtercard Installation Instructions - Manual (Page 6)

6 EtherNet/IP Daughtercard
Publication 1788-IN054A-EN-P - September 2002
1. Use an RJ45 connector to connect to the EtherNet/IP network. Wire the
connector according to this illustration:
2. Attach the connector to the EtherNet/IP port on the daughtercard.
Apply Host Power
To power the EtherNet/IP daughtercard, apply power to the host.
Daughtercard System Performance
Due to wide variation in available host devices, we cannot provide specific
performance capabilities in this document. For information concerning
host/daughtercard performance characteristics, refer to the user manual for the
particular host device.
IMPORTANT
We recommend connecting the module to the network via a
100MB Ethernet switch, which will reduce collisions and lost
packets and increase network bandwidth.
For detailed EtherNet/IP connection information, see the
following publications:
– EtherNet/IP Performance and Application Guide,
publication ENET-AP001
– EtherNet/IP Media Planning and Installation Guide,
publication ENET-IN001
8 ------ NC
7 ------ NC
6 ------ RD-
5 ------ NC
4 ------ NC
3 ------ RD+
2 ------ TD-
1 ------ TD+