Rockwell Automation 1788-ENBT EtherNet/IP Daughtercard Installation Instructions - Manual (Page 9)

EtherNet/IP Daughtercard 9
Publication 1788-IN054A-EN-P - September 2002
Utilization Percent (U%) Indicator
This LED indicates utilization percent of the daughtercard only and does not
address the system performance of the daughtercard plus host.
Where to Find Information on Configuring the Daughtercard
Now that you have installed your EtherNet/IP daughtercard, you must configure it.
Refer to your FlexLogix System User Manual, publication 1794-UM001.
Condition Status Indicates Recommended Action
off less than 80%
utilization The I/O packet rate to/from this
daughtercard is less than 80% of
the available packet rate and less
than 80% of the 32 available I/O
connections are currently in use. Normal operation. No action required.
flashing
green 80% packet
rate reached The I/O packet rate to/from this
daughtercard is at least 80% of the
available packet rate (4000
packets/sec). That is, the I/O
packet rate is at least 3200
packets/sec. Normal operation. No action required.
80%
connections in
use At least 80% of the 32 available
connections are currently in use.
That is, from 26 to 31 I/O
connections are in use. Normal operation. No action required.
green all connections
in use All 32 of the daughtercard’s I/O
connections are currently in use. Normal operation when all 32 I/O
connections are in use.
flashing
red/green self-test The daughtercard is performing its
power-up self-test. Normal operation during powerup.