Rockwell Automation 1762-IF4 MicroLogix Analog Input Module - Manual (Page 19)

MicroLogix 1762-IF4 Analog Input Module 19
Publication 1762-IN012C-EN-P - June 2013
Error Codes
The 1762-IF4 module notifies the controller of critical and non-critical errors. The module
condition array word 0 contains the error codes that are generated by the module, as shown
below.
The table below describes the module error codes.
“Don’t Care” Bits Module Error Extended Error Information
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Hex Digit 4 Hex Digit 3 Hex Digit 2 Hex Digit 1
Error Type Hex
Equivalent (1)
(1) X represents “Don’t Care”.
Module
Error Code Extended Error
Information Code Error Description
Binary Binary
No Error X000 000 0 0000 0000 No error
General Common
Hardware Error X200 001 0 0000 0000 General hardware error; no
additional information
X201 001 0 0000 0001 Power-up reset state
Hardware-
Specific Error X300 001 1 0000 0000 Reserved
Configuration
Error X400 010 0 0000 0000 General configuration error; no
additional information
X401 010 0 0000 0001 Invalid range select (Channel 0)
X402 010 0 0000 0010 Invalid range select (Channel 1)
X403 010 0 0000 0011 Invalid range select (Channel 2)
X404 010 0 0000 0100 Invalid range select (Channel 3)
X405 010 0 0000 0101 Invalid filter select (Channel 0)
X406 010 0 0000 0110 Invalid filter select (Channel 1)
X407 010 0 0000 0111 Invalid filter select (Channel 2)
X408 010 0 0000 1000 Invalid filter select (Channel 3)
X409 010 0 0000 1001 Invalid format select (Channel 0)
X40A 010 0 0000 1010 Invalid format select (Channel 1)
X40B 010 0 0000 1011 Invalid format select (Channel 2)
X40C 010 0 0000 1100 Invalid format select (Channel 3)