Rockwell Automation 1762-OA8 Solid State Output Module - Manual (Page 7)

Solid-State Output Module 7
Publication 1762-IN007B-EN-P- June 2013
System Assembly
The expansion I/O module is attached to the controller or another I/O module by means of a
flat ribbon cable after mounting as shown below.
Field Wiring Connections
Grounding the Module
This product is intended to be mounted to a well-grounded mounting surface such as a metal
panel. Refer to Industrial Automation Wiring and Grounding Guidelines, Allen-Bradley
publication
1770-4.1 , for additional information.
TIP Use the pull loop on the connector to disconnect modules. Do not pull on
the ribbon cable.
ATTENTION
EXPLOSION HAZARD
• In Class I, Division 2 applications, the bus connector must be fully
seated and the bus connector cover must be snapped in place.
• In Class I, Division 2 applications, all modules must be mounted in
direct contact with each other as shown on Page 6. If DIN rail
mounting is used, an end stop must be installed ahead of the controller
and after the last 1762 I/O module.