Rockwell Automation 1771-OAD AC(12-120V)Output Installation Instructions - Manual (Page 6)

AC (12-120V) Output Module 6
Publication 1771ĆIN024B-EN-P - November 2002
ATTENTION
!
Do not put the module jumper in CSI mode when
you use this module in a complementary mode.
Your system will not operate properly.
To change the fuse blown jumper to the CSI mode:
1. Locate the fuse-blown jumper at the top-right edge of the module
circuit board, as shown.
STD CSI
Fuse Blown Jumper
(shown in preset
STD position)
TopĆright edge of circuit board
12636ĆI
2. Use your finger to slide the jumper off the STD position (the
middle post and the left post).
3. Carefully reposition the jumper by sliding it onto the CSI position
(the middle post and the right post).