Rockwell Automation 6001-F2E AB STANDARD DRIVER SFTW - Manual (Page 10)

Installing the Standard Driver Software
Chapter 2
2-3
Example Files
The following files contain working 6001-F2E Standard Driver
application examples:
This file Contains
F2EDIAG.C diagnostic routines
F2ESLC.C unprotected read and unprotected write routines
SCREEN.H definitions and declarations required to compile F2EDIAG.C or
F2ESLC.C
This section tells you how to install the Standard Driver hardware and
software.
Installing the Hardware
To install the Standard Driver hardware:
1. Set the 1784-KR memory address switches and jumper settings that
are compatible with your computer system (See the 1784-KR
Installation Data, publication 1784-2.23, for instructions on setting
these switches.)
2. Record these addresses on a piece of paper. You will need them
when you configure the software.
Installing the Standard Driver
Hardware and Software