Rockwell Automation 2708-NNM Network Manager Software - Manual (Page 19)

Chapter 3
The Menus
3–7
Begin a Loaded Program
Programs that are loaded into a workstation that have terminated or been
terminated can be restarted with this command.
If you choose to start a program that resides in the workstation’s file memory,
as opposed to the program currently in the program memory (the default
program) you must enter the programs name and press
<ENTER>.
To start the program that is in the workstation’s program memory, simply
press <ENTER> to this query.
The second query allows you to specify a particular workstation or all the
workstations.
Abort a Program
A program that is running in a workstation can be terminated by this
command.
Change Configuration / Network Layouts
The Network Layout is used to define the role of each workstation in the
network. This is information that must be supplied for NM to work properly.
NM matches this information with information it retrieves from all the
units
to determine their online status.
Workstations can be added to the list by pressing the <DOWN ARROW> key
until no station numbers are highlighted. At this time you can press the
<ENTER> key to add a station. After pressing <ENTER> the screen should be
similar to the following:
Edit Station ( 2 )
Terminal Number of master/sub–master : 1
Terminal Number of this station : 2
Terminal type of this station : Normal station (backbone)
Terminal location in building :
Cabling description/location info :
Terminal uses A-B VBASIC programs : Yes
Terminal temporarily out of service : No
Note: In this menu, “Terminal” = workstation.
The Main Menus (cont’d)