Rockwell Automation 2708-NNM Network Manager Software - Manual (Page 35)

Chapter 4
The Basics
4–5
After allowing NM to collect data for awhile and you would now like to
manipulate the data retrieved, simply keep hitting
<ESC> until you are at the
main menu then press <F10>/‘X’ to exit the program. If any data is remaining
in the workstations it will be placed in a que for future transmission to NM.
You can now manipulate the data retrieved in any way necessary.
Another Way To Collect The Data
When starting NM use the following syntax NM /X. This will start up LIO
and it will collect data from the network. When NM receives approximately
100 no data acknowledgements from the master “*”, the program will
terminate automatically.
Starting Up NM (cont’d)