Rockwell Automation 6180 RAC6180 Display and Backlight Installation Instructions - Manual

Display and Backlight
(For 6180 Industrial Computers)
This instruction sheet describes how to replace the following
displays and backlights for 6180 Industrial Computers. All display
kits contain a hinge pin and 3 chassis latching screws.
Item See Page
10.4 Inch Bezel / Display 4
10.4 Inch Touchscreen / Display 4
11.3 Inch Bezel / Display 4
11.3 Inch Touchscreen Bezel / Display 4
Plastic Bezel No Display 4
Replacement Backlight (Catalog No. 6189-NL2)
10.4 Inch Display Only
2
The backlight uses Cold Cathode Fluorescent (CCF) tubes to
illuminate the display. The 11.3 inch displays have an integral
backlight that cannot be replaced separately, the entire bezel / display
must be replaced. The 10.4 inch backlight is replaceable.
!
ATTENTION: Disconnect all power from the 6180
Computer before replacing the backlight. Failure to
disconnect power may result in electrical shock and/or
damage to the terminal.
!
ATTENTION: Do not touch any of the exposed
electronic components to prevent damage from
electrostatic discharge (ESD).
Instructions
Applications
Overview & Safety