Rockwell Automation 6180 RAC6180 Display and Backlight Installation Instructions - Manual (Page 4)

Display and Backlight 4
The procedures for replacing 11.3 and 10.4 inch bezel/displays are
the same. For purposes of illustration we show the 11.3 inch display.
If you are installing a bezel with no display, the procedures are the
same except for the number of electrical connectors to the bezel.
To remove a 10.4 or 11.3 inch bezel/display:
1. Disconnect the power from the 6180 Computer.
2. Disconnect all communication and power cables.
3. Remove the clips or mounting stud nuts that secure the computer
to the panel.
Important: There is metal tab that temporarily locks the bottom
of the chassis in the panel during mounting. This tab must be
bent in before bezel / chassis can be removed.
П
П
Bezel
Gasket
Locking Tab
Panel
4. Remove the computer from the panel or enclosure.
Replacing the
10.4, 11.3 Inch Displays
or Bezel with No Display