Rockwell Automation 6180 RAC6180 Display and Backlight Installation Instructions - Manual (Page 3)

Display and Backlight 3
Backlight
Power
Supply
Cable
(4) M4 Phillips Screws
5. Remove four screws that secure backlight and remove the
backlight to allow access to the power connector
6. Unplug the backlight power supply cable and remove the
backlight.
7. Plug the backlight power supply cable into the new backlight.
8. Place the backlight on the four backlight standoffs.
9. Replace the four backlight mounting screws and tighten to a
torque of 6 to 8 inch-pounds (.7 to .9 N
Sm).
10. Swing the chassis back into position and tighten the three latching
screws to a torque of 18 to 22 inch-pounds (2 to 2.5 N
Sm).
11. Reconnect and install any external cables or mounting clips.
12. Apply power and verify operation of the backlight.