Rockwell Automation 6180 RAC6180 Display and Backlight Installation Instructions - Manual (Page 7)

Display and Backlight 7
To install a 10.4 or 11.3 inch display:
1. Secure the bezel/display to the chassis by aligning the hinges and
installing the hinge pin.
2. Connect the electrical connectors between the bezel/display and
the chassis. The connectors are different sizes and each is keyed
so that they cannot be installed incorrectly. Do not force a
connector.
3. Swing the chassis closed. Make sure the bezel/display cables and
connectors move freely and do not crimp when the chassis is
closed.
4. Secure the chassis with the three latching screws. Use the new
screws provided.
5. Mount the 6180 Computer in the the enclosure or panel, refer to
the 6180 Industrial Computer user manual.
6. Apply power and verify operation of the display.