Rockwell Automation 6180 RAC6180 Display and Backlight Installation Instructions - Manual (Page 2)

Display and Backlight 2
To replace the backlight (10.4 inch displays only):
1. Disconnect the power from the 6180 Computer.
2. Remove the three latching screws that secure the chassis to the
front bezel
Front Bezel
Latching Screws (3)
3. Note the following precautions before swinging the chassis
away from the bezel.
!
ATTENTION: Remove all external cables from the
side panel connectors. Failure to remove cables may
cause damage to the cables and connectors.
!
ATTENTION: If the 6180 Computer is installed with
mounting clips, the mounting clips on the hinge side
will interfere with the opening of the hinge. Remove
the mounting clips on the hinge side before swinging
chassis away from the bezel. Failure to remove clips
may damage clips and the chassis.
4. Swing the chassis open about 90
_.
Replacing the 10.4 Inch
Display Backlight