Rockwell Automation 2711 PanelView 300 Keypad Terminal Installation Instructions - Manual (Page 11)

PanelView 300 Keypad Terminals 11
Publication 2711-IN027C-EN-P - February 2009
2. Secure the Earth Ground wire to the correct terminal block screw.
3. Apply 24V DC power to the terminal.
Battery Removal and Disposal
The terminal contains a lithium battery, which is intended to be replaced during the
life of the product.
ATTENTION
Explosion Hazard - Do not connect or disconnect equipment while circuit is
live unless area is known to be non–hazardous.
Do not apply power to the terminal until all wiring connections have been
made. Failure to do so may result in electrical shock.
ATTENTION
The clock module contains lithium. Do not dispose of the battery in a fire or incinerator, or
the clock module may explode. Follow disposal regulations in your area for lithium
battery disposal.
IMPORTANT
The 2711-K3A5L1K terminal is the conformal coated version, which has the battery
sealed. It cannot be replaced.
+
Earth Ground
DC Negative
DC Positive
Power Terminal
Block (fixed)