Rockwell Automation 2711 PanelView 300 Keypad Terminal Installation Instructions - Manual (Page 3)

PanelView 300 Keypad Terminals 3
Publication 2711-IN027C-EN-P - February 2009
Hazardous Location Considerations
This equipment is suitable for use in Class I, Division 2, Groups A, B, C, D; Class II,
Division 2, Groups F and G; Class III Division 2; or non-hazardous locations only.
The following WARNING statement applies to use in hazardous locations.
See the nameplate on terminal for hazardous locations certifications.
The PanelView 300 terminals have an operating temperature code of T4
(maximum operating temperature of 135 °C or 275 °F). Do not install the terminals
in environments where atmospheric gases have ignition temperatures less than
135 °C (275 °F).
European Union Directive Compliance
If this product has the CE mark it is approved for installation within the European
Union and EEA regions. It has been designed and tested to meet the following
directives.
WARNING
EXPLOSION HAZARD
• Substitution of components may impair suitability for Class I, Class II, Class III
Division 2.
•
Do not replace components or disconnect equipment unless power has been
switched off or the area is known to be non-hazardous.
•
Do not connect or disconnect components unless power has been switched off
or the area is known to be non-hazardous.
• This product must be installed in an enclosure. All cables connected to the
product must remain in the enclosure or be protected by conduit or other means.
•
All wiring must comply with N.E.C. article 501-4(b), 502-4(b), 503-3(b) as
appropriate.
ATTENTION
In Class I, Class II, Class III Division 2 Hazardous locations, the PanelView 300
terminal must be wired per the National Electric Code as it applies to hazardous
locations. Peripheral equipment must also be suitable for the location in which it is
installed.