Rockwell Automation 2711 PanelView 300 Keypad Terminal Installation Instructions - Manual (Page 8)

8 PanelView 300 Keypad Terminals
Publication 2711-IN027C-EN-P - February 2009
5. Install the 4 self-locking nuts, hand tight.
6. Alternately tighten the self-locking nuts until the terminal is held firmly
against the panel. Tighten the nuts to a torque of 1.13 N•m (10 lb•in). Do
not overtighten nuts.
7. Remove the protective installation label covering the top vents of the
terminal.
ATTENTION
Mounting nuts must be tightened to a torque of 1.13 N•m (10 lb•in) to
provide a proper seal and to prevent potential damage to the terminal.
Allen-Bradley assumes no responsibility for water or chemical damage to the
terminal or other equipment within the enclosure because of improper
installation.
ATTENTION
Failure to remove the protective installation label covering the top vents
could result in overheating and damage to the terminal.
Protective
Installation
Label
Self-locking Nuts
(4 used, 6 provided)
Mounting Studs
(2 left / 2 right)