Additional resources – Rockwell Automation 2080-LC10-12AWA_12QWB_12QBB_12DWD Micro810 12 Point 24V/12V DC Programmable Controllers User Manual
Page 6
6 Micro810 12 Point Programmable Controllers
Publication 2080-IN006B-EN-P - April 2014
Additional Resources
If you would like a manual, you can:
• download a free electronic version from the Internet:
• purchase a printed manual by contacting your local Allen-Bradley distributor or
Rockwell Automation representative
ATTENTION:
•
Do not wire more than 2 conductors on any single terminal.
•
Be careful when stripping wires. Wire fragments that fall into the controller
could cause damage. Once wiring is complete, make sure the controller is
free of all metal fragments.
•
Do not remove the protective debris strips until after the controller and all
other equipment in the panel near the module are mounted and wired.
Remove strips before operating the controller. Failure to remove strips
before operating can cause overheating.
•
Electrostatic discharge can damage semiconductor devices inside the
module. Do not touch the connector pins or other sensitive areas.
•
The USB cable is not to exceed 3.0 m (9.84 ft).
•
This product is intended to be mounted to a well-grounded mounting surface
such as a metal panel. Additional grounding connections from the power
supply's mounting tabs or DIN rail (if used) are not required unless the
mounting surface cannot be grounded.
Refer to Industrial Automation Wiring and Grounding Guidelines,
Allen-Bradley publication
r additional information.
Resource
Description
Micro810
®
Programmable Controllers User
Manual, publication
A more detailed description of how to install and use your
Micro810 programmable controller.
Micro800
®
AC Power Supply Installation
Instruction, publication
Information on wiring and installing the optional AC power supply.
Industrial Automation Wiring and
Grounding Guidelines, publication
More information on proper wiring and grounding techniques.