Rockwell Automation 2706-ND1 DL40 OFFLINE PROGRAMMING SFTWR.USER MANUAL - Manual (Page 120)

Chapter 8
The Files Menu
8 – 5
Copy File(s) lets you perform the following actions:
•
copy a single file within the same directory. You must specify a new
filename for the copy.
•
copy a single file to a different drive and/or directory. You may specify a
new filename for the copy or retain the original filename. Note that two
copies of the file will exist when the copy is complete (see page 8 – 7).
•
copy multiple files to a different drive and/or directory. Original file
names will always be retained when copying multiple files.
To copy the selected file(s), move the cursor to Copy File(s) and press [
↵
] .
The Copy Files pop-up window will open.
Figure 8.4
Copy Files pop-up window
File Picks pop-up window
indicates what files are
currently selected.
Copying single files
To copy your selection to a new drive and/or directory, type the destination in
the Copy Files pop-up window in the form:
Drive:\directory\filename
To copy your selection to the same drive and directory, you do not need to
specify a drive or directory. Instead, type only the new filename in the Copy
Files pop-up window in the form:
filename
Press [
↵
] to accept your destination and start the copy.
Copy File(s)