Rockwell Automation 2706-ND1 DL40 OFFLINE PROGRAMMING SFTWR.USER MANUAL - Manual (Page 99)

Chapter 6
The Transfer Menu
6 – 11
!
ATTENTION: Before the download begins, you will see one of
the following warnings. Which one you see depends on the type
and access settings of your DH+ or Ethernet hardware device.
WARNING: Incorrect address selection could corrupt data in
a non-DL40 device. Verify that the correct Communication
File is selected.
WARNING: Incorrect address selection could corrupt data in
a non-DL40 device. Verify that the correct Communication
File is selected.
DH+ Network Access is set to Local.
WARNING: Incorrect address selection could corrupt data in
a non-DL40 device. Verify that the correct Communication
File is selected.
DH+ Network Access is set to Remote (Bridge)
– Local Address is __.
– Remote Bridge Address is __.
Be sure the selected communication file has the correct
address parameters, and change them if necessary before
continuing.
NOTE: When downloading via Remote I/O, Download Type is
automatically set to All . You can’t transfer just Parameters .