Rockwell Automation 2707-M232P3xX, -M485P3X DTAM Micro Operator Interface Installation Instructions - Manual (Page 14)

DTAM Micro Operator Interface 14
Class 1 Division 2 Groups A, B, C, D, hazardous locations
(Series B or higher)
NEMA Type 4, 12, 13 (indoor use only)
Class 1 Division 2 Groups A, B, C, D, hazardous locations
(Series D or higher)
Series C or higher (2707–M232P3, –M485P3)
Series A or higher (2707–M232P3D)
If this product is installed within the European Union or EFTA
regions, the following regulations apply:
!
ATTENTION: To maintain compliance with
European Union Directives there must exist at least 2.5
cm (1 in.) free air space around the sides and back of
this unit when installed in an enclosure.
This apparatus is tested to meet Council Directive 89/336
Electromagnetic Compatibility (EMC) standards:
•
EN50081–2 Class A (Industrial) Emissions
•
EN50082–2 Class A (Industrial) Immunity
•
EN61000–6–2 Class A (Industrial) Immunity – (Series E Only)
According to these Standards, the factor which determines, for EMC
pruposes, whether an apparatus is deemed to be “Industrial” or
“Residential, commercial and light industrial”, is given in Clause 1
of EN50081–2 as follows:
Apparatus covered by this standard is not intended for
connection to a public mains network, but is intended to be
connected to a power network supplied from a high– or
medium–voltage transformer dedicated for the supply of an
installation feeding a manufacturing or similar plant.
The product described in this document is intended solely for use in
an industrial environment as defined above. When installed in
Europe, any other application is in contravention of the European
Union Directives, and a breach of those laws.
Agency Ratings
European Union Directive
Compliance