Rockwell Automation 2707-M232P3xX, -M485P3X DTAM Micro Operator Interface Installation Instructions - Manual (Page 3)

DTAM Micro Operator Interface 3
!
ATTENTION
CAUTION: USE ONLY WITH CLASS 2 POWER
SOURCE LIMITED TO 30 VDC OPEN CIRCUIT
AND 8A SHORT CIRCUIT.
ATTENTION: UTILISER AVEC UNE TENSION
D’ALIMENTATION CLASSE 2 DE 30 VCC MAXI
EN CIRCUIT OUVERT AVEC UN COURANT DE
COURT-CIRCUIT DE 8A MAXI.
!
DANGER
EXPLOSION HAZARD: DO NOT CONNECT OR
DISCONNECT EQUIPMENT WHILE CIRCUIT IS
LIVE UNLESS AREA IS KNOWN TO BE
NON-HAZARDOUS
RISQUE D’EXPLOSION: NE PAS BRANCHER
OU DEBRANCHER TANT QUE LE CIRCUIT EST
SOUS TENSION, A MOINS QU’IL NE S’AGISSE
D’UN EMPLACEMENT NON DANGEREUX.
The terminal must be mounted in a panel or enclosure to protect the
internal circuitry. The terminal meets NEMA Type 4, 12, 13 (indoor
use only) ratings only when mounted in a panel or enclosure with the
equivalent rating.
Allow enough spacing within an enclosure for adequate ventilation.
For some applications, you may have to consider heat produced by
other devices within a panel. The ambient temperature around the
terminal must be maintained between 32
_ – 131_ F (0_ – 55_ C).
Make sure that provisions are made for accessing the back panel of
the terminal for wiring, routine maintenance, and troubleshooting.
Enclosures