Rockwell Automation 6181P_F VersaView 6181P Integrated Display Computers Install - Manual (Page 14)

14 Integrated Display Computers
Publication 6181P-IN001I-EN-P - July 2008
Connect AC Power
A standard IEC 320 power cord provides power to the computer. The power supply
input accepts 120/240V AC. The power supply is autoswitching.
Operate the computer in an industrial or control room environment, which uses
some form of power isolation from the public low voltage mains.
ATTENTION
Connect the AC power cord to a power source with an earth ground to prevent electrical
shock. Failure to follow this warning could result in electrical shock.
The computer circuit should have its own disconnect. Use an Uninterruptible Power
Source (UPS) to protect against unexpected power failure or power surges.
Always shut down the operating system before removing power to minimize performance
degradation and operating system failures.
1200P only:
You many need to remove the AC retainer
clip before installing the unit in a panel.
Reattach the clip after installing the unit.