Rockwell Automation 6181P_F VersaView 6181P Integrated Display Computers Install - Manual (Page 8)

8 Integrated Display Computers
Publication 6181P-IN001I-EN-P - July 2008
Required Tools
The following tools are required for product installation.
•
Panel cutout tools
•
#2 Phillips screwdriver
Panel Mounting Guidelines
Observe these guidelines when installing the unit in a panel.
•
Confirm that there is adequate space within the panel enclosure.
•
Cut supporting panels to specifications before installation. Take precautions
so that metal cuttings do not enter components already installed in panel.
•
Supporting panels must be at least 14 gauge to ensure proper sealing against
water and dust and to provide proper support. The mounting hardware
supplied accommodates panels up to 6.25 mm (0.25 in) thick.
Panel Cutout Dimensions
Mount the Computer in a Panel
Follow these steps to mount the monitor in a panel.
1. Remove power from the panel.
ATTENTION
Failure to follow these guidelines may result in personal injury or damage to the panel
components.
Computer Model Cutout Dimensions (H x W)
1200P 254.0 x 324.0 mm (10.0 x 12.76 in)
1500P 285.0 x 386.6 mm (11.24 x 15.22 in)
1700P 329.5 x 424.0 mm (12.97 x 16.69 in)
ATTENTION
Remove all electrical power from the panel before making cutout.
Make sure the area around the panel cutout is clear.
Failure to follow these warnings may result in personal injury or damage to the panel
components.