Rockwell Automation 6181P_F VersaView 6181P Integrated Display Computers Install - Manual (Page 16)

16 Integrated Display Computers
Publication 6181P-IN001I-EN-P - July 2008
Connect to the Network
The computer connects to the Ethernet network using CAT5 or CAT5E twisted pair
Ethernet cabling with RJ45 connectors.
Replace the Battery
The computer contains a lithium battery to maintain CMOS settings and the
real-time clock. The battery is in a battery holder on the computer’s CPU board.
Replace this battery as needed with a Panasonic battery, part number CR2032, or
equivalent.
Backlight Disposal
IMPORTANT
To prevent performance degradation of Ethernet communication, do not subject the
computer or cables to extreme radiated or conducted high-frequency noise.
Proper cable routing and power conditioning is required to ensure reliable Ethernet
communication in industrial environments. Rockwell Automation recommends that you
route all Ethernet cabling through dedicated metal conduits. Installing ferrite bead filters
at the cable ends may also improve reliability.
WARNING
To avoid the danger of explosion, only replace the battery with part number CR2032 or a
recommended equivalent. Dispose of used batteries according to the manufacturer’s
instructions.
ATTENTION
The backlight assembly in this unit contains mercury. At the end of its life, this equipment
should be collected separately from any unsorted municipal waste.