Rockwell Automation 2100 CENTERLINE Motor Control Center (MCC) Units with Vertical Operating Handles - Manual (Page 14)

14 Rockwell Automation Publication 2100-IN014F-EN-P - March 2014
CENTERLINE 2100 Motor Control Center (MCC) Units with Vertical Operating Handles
Extend SecureConnect Unit
Power Stabs Follow this procedure to extend the SecureConnect unit power stabs.
1. Verify that the disconnect handle is in the OFF/O position.
2. Insert 1/4 in. hex tool into shaft port and rotate tool clockwise.
The indicator next to the disconnect handle changes from green to red.
Additional Resources These documents contain additional information concerning related products
from Rockwell Automation.
You can view or download publications at http://
www.rockwellautomation.com/literature/ . To order paper copies of technical
documentation, contact your local Allen-Bradley distributor or Rockwell
Automation sales representative.
Resource Description
CENTERLINE 2100 Low Voltage Motor Control Centers
Instruction Manual, publication
2100-IN012
Provides general instructions for MCC Units.
CENTERLINE 2100 Motor Control Center Units with
Horizontal Operating Handles, publication
2100-IN060
Provides information on installing units with horizontal
operating handles.
Safety Guidelines for the Application, Installation, and
Maintenance of Solid- state Control Installation
Instructions, publication
SGI-1.1
Provides safety guidelines for the application, installation,
and maintenance of solid-state control.
Industrial Automation Wiring and Grounding Guidelines,
publication
1770-4.1
Provides general guidelines for installing a Rockwell
Automation® industrial system.
Product Certifications website, http://
www.rockwellautomation.com/products/certification
Provides declarations of conformity, certificates, and other
certification details.