Rockwell Automation 2100 CENTERLINE Motor Control Center (MCC) Units with Vertical Operating Handles - Manual (Page 3)

Rockwell Automation Publication 2100-IN014F-EN-P - March 2014 3
CENTERLINE 2100 Motor Control Center (MCC) Units with Vertical Operating Handles
Before You Begin Follow this procedure before you begin installing your unit.
1. Remove all packaging material from the unit.
2. Read the unit installation instructions.
3. Familiarize yourself with the unit.
4. Inspect unit for shipping damage.
5. For SecureConnect™ units, verify that power stabs fully extend and retract.
ATTENTION: When installing units for CENTERLINE 2100 Motor Control Centers
with ArcShield™ baffles, you must make sure you are installing a unit that has
the same arc resistance rating as the MCC in which it is being installed. Units
that are not rated for 100 ms arc duration must not be installed in a section that
is rated for 100 ms arc duration. The arc resistant rating will not apply if that is
done.
ATTENTION: SecureConnect units must be installed in Series P or later
CENTERLINE 2100 Motor Control Centers. If installing a SecureConnect unit in a
Series N or earlier MCC, you must have compatible bus covers installed. For more
information, contact your local Allen-Bradley® distributor or Rockwell
Automation sales representative.
Unit
Unit Door
Unit Support Pan