Rockwell Automation 6180 Keypad Configuration Utility Floppy Disk Drivers (for 6180 Industrial Computer - Manual (Page 3)

Keypad Configuration Utility 3
The Keypad Configuration Utility software is pre-installed on 6180
Industrial Computers that are shipped with the Windows operating
system and a keypad.
Installation disks are supplied with all 6180 Industrial Computers.
To install the Keypad Configuration Utility software:
1. Insert Disk 1 in Drive A: or Drive B:
2. Click the Start button, click Settings and then click the Control
Panel.
3. Double-click the Add/Remove Programs icon.
4. On the Install/Uninstall tab, click the Install button.
Note: You can also uninstall the Keypad Configuration utility
from this tab.
5. Follow the install instructions on the screen.
or
1. Insert Disk 1 in Drive A: or Drive B:
2. Click the Start button and select Run from the menu.
3. Enter a:\setup in the Run dialog and click OK.
4. Follow the install instructions on the screen.
The KIC Utility recognizes three file types.
File Type Description
.KEY Keypad configuration file
.BOO
Boot firmware file. Cannot be edited. Supplied by Allen-Bradley
when upgrades of the boot code firmware are required.
.APP
Application firmware file. Cannot be edited. Supplied by
Allen-Bradley when upgrades of the application firmware are
required.
All file types can be downloaded to the Keyboard Interface
Controller (KIC) in the 6180 Industrial Computer.
Installing the Keypad
Configuration Utility
File Types