Rockwell Automation AutoMax Enhanced Ladder Language Reference Manual - Manual (Page 57)

3Ć17
3.4.2 Output Parameters for the TP Instruction
This table lists the outputs for the TP instruction and the variable type and data
type/range that each output supports.
Parameter Description Variable Type Data Type/Range
ENO Use this output as the input to another instruction for
easily chaining multiple instructions. ENO follows the state
of EN.
Connect a contact coil or Boolean input to
Q, T These outputs are set true when EN is true and the value
in Elapsed is less than that in TPreset. Q and T remain
true while the value in Elapsed is less than the value in
TPreset.
These outputs are set false when the value in Elapsed
equals the value in TPreset.
Connect a contact, coil, or Boolean input to
another instruction.
Elapsed This value is specified in increments of 0.01 seconds. This
value is incremented when EN is true, until its value
equals that of TPreset. The Elapsed value is reset to zero
when EN is false and Elapsed and TPreset are equal.
The value in Elapsed is stored in the element
name.Elapsed and will not exceed the TPreset value when
the instruction is enabled.
constant double integer
(0 to 2147483647)
0 to 248.5 days in
0.01 second intervals