Rockwell Automation 6181F_P Series E Integrated Display Computers Installation Instructions - Manual (Page 17)

Industrial Integrated Display Computers 17
Rockwell Automation Publication 6181P-IN010F-EN-P - July 2013
Apply Power
The computer connects to either a 100…240V AC or 18…32V DC power source, depending on
the model.
We recommend that the computer circuit has its own disconnect. Use an uninterruptible power
source (UPS) to protect against unexpected power failure or power surges.
Always shut down the operating system before removing power to minimize performance
degradation and operating system failures.
Remove the AC retention clip, if necessary, before installing the computer in a panel cutout.
Reattach the clip after installing the computer.
Connect AC Power to Performance and Non-display Computers
A grounded 3-prong IEC320 power cord provides power to a computer with an AC power
input. The power supply input accepts 100…240V AC and is autoranging.
Follow these steps to connect AC power to performance and non-display computers.
1. Connect the power cord to the AC power input (1).
2. Secure the power cord in place with the retention clip (2).
3. Apply 100…240V AC power to the computer.
SHOCK HAZARD: Connect the AC power cord or the DC ground connection to a power source with
an earth ground. Failure to follow this warning could result in electrical shock.
TIP If using an alternate IEC320 cord, make sure the female end of the cord is sized appropriately
for the retention clip.
2
1