Rockwell Automation 2705-APG RediPanel Plug and Go Products - Manual (Page 12)

Bulletin 2705
RediPANEL 800A Push Button Modules
User Manual
12
To connect wires to the power connection from the power source, follow
these easy steps (see Figures 5 and 6):
1. Remove the power connector from the receptacle.
2. Loosen left and right screws on the power connector and insert the wires
into the openings on the bottom of the power connector, being certain that
the correct polarity is observed between the power connection and the
power source.
3. Tighten the screws on the power connector and insert the power connector
into the receptacle.
To connect the preassembled cables between the RediPANEL and I/O
modules, follow these easy steps:
1. Remove the tie wrap from the back of the RediPANEL and place it over
the cable at a distance of 8” from the end.
2. Insert the proper cable (see Table 2 ) into the appropriate connection
terminal (input or output) and secure with locking tabs.
3. Be certain that the distance from the end of the cable to the tie wrap is
8”, then reinstall the tie wrap to the back of the RediPANEL. See Figure 7
below.
Figure 7
Side view of Push button Module
2.6 (66.0) 16 PB
2.7 (68.6) 32 PB
8.0
(203.2)
1.50 (38.1)
Max.
4.0 (101.6) 16 PB
4.5 (114.3) 32 PB
Dimensions in inches (millimeters)