Modification and replacement procedures, Custom 800a redipanel modules, Installing or replacing push button legends – Rockwell Automation 2705-APG RediPanel Plug and Go Products User Manual
Page 19
Bulletin 2705
RediPANEL 800A Push Button Modules
User Manual
19
Custom 800A RediPANEL Modules
If the standard configuration modules with momentary push buttons do not
meet your requirements, 800A custom modules are available. Custom
modules can contain any combination of the following Bulletin 800A
devices:
Momentary Illuminated Push Buttons
Maintained Illuminated Push Buttons
Two Position Selector Switches
Flush Head or Extended Head Operators
Two Position Key Switches
Installing or Replacing Push Button Legends
!
ATTENTION: To avoid electrical shock or unintended operation
of the equipment, disconnect power before servicing.
1. Remove the lens carrier from the push button on the module by gently
prying it out on either side of the carrier with a screwdriver.
!
ATTENTION: DO NOT use the slot on either side of the lens
carrier for prying as it may break the assembly.
2. Remove the color lens by placing a small screwdriver into the slot on the
back of the lens carrier and gently prying the two pieces apart.
!
ATTENTION: DO NOT use too much pressure in prying the
assembly apart as it can damage the colored lens.
ОО
ЛЛЛ
ЛЛЛ
ЛЛ
ЛЛ
ЛЛЛ
ЛЛЛ
ЛЛЛ
ОО
ОО
ЛЛЛ
ЛЛЛ
ЛЛ
ЛЛ
ЛЛ
ЛЛ
ОО
ОО
ОО
Л
Л
ЛЛЛ
ЛЛЛ
ЛЛ
О
STEP 1
STEP 2
Modification and Replacement
Procedures