Rockwell Automation 2706-P_P InView Quick Start - Manual (Page 2)

Publication 2706-QS001D-EN-P - January 2009
2 InView Marquee Message Display
Equipment Setup
Connect a power cord or power supply and catalog number
2706-PCABLE1, series A, to the InView display and to COM1 of the
computer.
Configure the Display
Follow these steps to configure the display.
1. Install the InView Messaging software.
Refer to the installation instructions included on the CD.
2. Launch the InView Software from Start > Programs > Rockwell
Automation > InView Software > InView Messaging Software.
3. After opening the software, click Create New InView Project and
click OK.
TIP
Verify RSLinx software is not using the serial port.