Rockwell Automation 2706-P_P InView Quick Start - Manual (Page 21)

Publication 2706-QS001D-EN-P - January 2009
InView Marquee Message Display 21
4. In the Ethernet TCP/IP Communications dialog box, type the IP
Address of the 2706-PENET1 module, the MAC Address of the
communication module, and the Subnet Mask.
5. Click Setup to make the changes in the communication module
and click OK to finish.
IMPORTANT
There are two Setup buttons. You need to set the IP and MAC as
stated in step 4. Click the first Setup button and then restart the
2706-PENET1 module. After it cycles power, click the next Setup
button.
TIP
Leave the Gateway Address blank unless required for your
application.
TIP
Your computer needs to be on the same subnet as the communication
module to set the communication.