Rockwell Automation 2711P-xxxx PanelView Plus 6 Terminals User Manual User Manual
Page 133
Rockwell Automation Publication 2711P-UM006C-EN-P - April 2013
133
Install and Replace Components
Chapter 5
3. Plug the DC power terminal block connected to the AC power supply
module into the terminal.
4. Insert the two short tabs on the AC module into the slots on the back
of the terminal.
5. Push down on the module until the two long tabs snap into the slots on the
opposite side of the terminal.
Make sure the module is securely connected and that the power supply
wires are not pinched between the module and the terminal.
6. Connect AC power to the terminal block on the AC module.
for details on how to wire power.
Follow these steps to remove the AC power module.
1. Disconnect power to the
terminal.
2. Remove the AC power wiring
from the power terminal block.
3. Insert a small, flat-blade
screwdriver into one of the two
slots below the AC module and
pry up carefully to release the tabs
from the slot.
4. Pull up on the front of the
module to release the back tabs.
5. Remove the DC power terminal
block and wiring from the
terminal.
4
5