Rockwell Automation 9220-TG QUICK START CONTROLNET MESSAGE User Manual
Page 13
ControlNet Message/Traffic Generator Tool
13
Publication 9220-10.1 — July 1996
Sending Unconnected Messages
You can send unconnected messages to:
•
send predefined unconnected messages
•
get attribute information on an object
•
reset a device
Sending Predefined Unconnected Messages
To send an unconnected message, choose Unconnected, Send Message,
and choose the message you want to send.
To
Choose this message
À
set the target nodes in the Listen Only mode
CNet Listen Only
send Keeper type messages when not in an operating network
Keeper 5ms, 15, 16
obtain loose parameters information
Keeper Loose Params
obtain the pending parameters
CNet Get Pending
obtain the current parameters
CNet Get Current
obtain diagnostic information
CNet Get Diags
À
These messages are defined in the tool’s configuration file, CNXOR.CFG.
Getting Attribute Information
To send an unconnected message to get attribute information, choose
Unconnected, Get Attr All, and choose the object you want attributes on.