Rockwell Automation 9220-TG QUICK START CONTROLNET MESSAGE User Manual
Page 22
ControlNet Message/Traffic Generator Tool
22
Publication 9220-10.1 — July 1996
Connection Setup (continued)
This resource
Description
Connection.___.timeout:
The UCMM timeout value used in an Open/Close
Connection message to the target Object. This value is
in hex.
Connection.mr.timeout: 0A
Connection.___.epr:
The Expected Packet Rate for the Connection being
established, expressed in the form of a 16–bit scaled
integer as described in the Connections in the
ASA Product Developer’s Guide, cat. no. 9250-DOC.
This value is in hex.
Connection.rackio.epr: 0E71
Connection.___.net_t_o:
Connection.___.net_o_t:
Specify the Net_T_O and Net_O_T values in the Open
message. These values are bit fields as described in the
Connections in the ASA Product Developer’s Guide,
cat. no. 9250-DOC. These values are in hex.
Connection.rackio.net_t_o: 281A
Connection.rackio.net_o_t: 480A
Connection.___.class:
Specifies the class number of the Object being
connected to. This value is in hex.
Connection.mr.class: 02
Connection.___.transport:
Specifies the Transport Class/Trigger value for the Open
message. The value is a bit field as described in the
Connections in the ASA Product Developer’s Guide,
cat. no. 9250-DOC. This value is in hex.
Connection.mr.transport: A3
Connection.___.path:
Specifies the path segment to be attached to the end of
the Open message. The path begins immediately
following the instance segment of the Open and typically
begins with the Connection point information. The path
is sent byte for byte as specified. The data bytes are
in hex.
Connection.rackio.path:
2c 02 2c 01 80 05 01 00 0c 00 18 00 01 01 02 00
Connection.___.1stmsg:
Specifies a message to be sent on the Connection
immediately after a successful Open has completed
(optional). This makes sure the Connection does not
timeout before you have a chance to send the first data
on the Connection. The value must be a name of a
message specified in Message.___.data.
Connection.rackio.1stmsg:
rout1
(see Message Setup)