Rockwell Automation 1440-VDRP06-00RH XM-160/161/162 Direct Vibration Module - Manual (Page 49)

Publication GMSI10-UM025C-EN-P - August 2010
Installing the XM-160/161/162 Direct Vibration Module 41
Figure 2.34 Velocity Sensor to Channel 3 Wiring
Figure 2.35 Velocity Sensor to Channel 4 Wiring
TYPICAL WIRING FOR COIL-BASED VELOCITY SENSOR
TO XM-160/161/162 DIRECT VIBRATION MODULE CHANNEL 3
Shield
Pin A - Signal
Pin B - Common
Cable shield not
connected at this end
7
23
Channel 1 Input Signal
Signal Common
2
Channel 3 Input Signal
TYPICAL WIRING FOR IEPE ACCELEROMETER
TO XM-160/161/162 DIRECT VIBRATION MODULE CHANNEL 4
Shield
Pin A - Signal
Pin B - Common
Cable shield not
connected at this end
9
25
Channel 1 Input Signal
Signal Common
41
Channel 4 Input Signal