Rockwell Automation SP120 AC Drive Demo Unit - Manual (Page 13)

Running the Demo Unit 4-1
C
HAPTER
4
Running the Demo Unit
The demo consists of three step-by-step labs to acquaint you
with the basic operation of the drive.
Purpose of the labs:
4.1 The Labs
Lab A: Reset the drive to factory defaults using the
following procedure.
Tools required: None
Step 1. Turn on the demo unit using the power switch.
Step 2. If a parameter number is not displayed, press the
PROGram key.
Step 3. Press ▲ or ▼ until b - - is displayed.
Step 4. Press PROGram to select the b parameter group.
Step 5. Press ▲ or ▼ until parameter b84 is displayed.
Step 6. Press PROGram to display the value of b84.
Step 7. Press ▲ or ▼ until 00 is displayed.
Step 8. Press to save the displayed value. b84 is
displayed again.
Lab A Learn the steps required to reset the drive
to factory defaults. This lab sets the drive
up for the next two labs. Run Lab A first.
Lab B Learn how to set up and run the drive in
local (keypad) operation.
Lab C Learn how to set up and run the drive in
remote (switches and speed pot)
operation.