Rockwell Automation FactoryTalk Historian SE 4.0 Live Data Interface User Guide - Manual (Page 51)

Rockwell Automation Publication HSELD-UM024A-EN-E–September 2013 51
Chapter 12
Error and Informational Messages
The FTLD Interface is based on the PI-UniInt framework,
therefore a few error messages are sent to the PIPC log by PI-UniInt.
Other error messages are sent to the FactoryTalk Diagnostics
system. When troubleshooting, we recommend that you check both
FactoryTalk Diagnostics and the PIPC log.
The following is the list of error messages sent to FactoryTalk
Diagnostics.
Severity Message text
Error Failed to disconnect from FactoryTalk.
Error Failed to initialize COM library.
Error Failed to initialize COM security.
Error Missing or invalid interface ID parameter.
Error Failed to initialize FactoryTalk Diagnostics.
Error Failed to launch FTLD interface due to the lack of the parameter
/FTDirectory.
Error Failed to launch FTLD interface due to the lack of the parameter
/FTContext.
Error Failed to connect to FactoryTalk Directory scope %s.
Error System error: Insufficient memory.
Warning Failed to remove FactoryTalk Live Data item <%s>.
Warning PI point <%s> is refused because of failure to add FactoryTalk Live
Data item <%s>.
Warning PI point <%s> is refused because of the invalid attribute of
Location [3].
Warning PI point <%s> is refused because of the invalid attribute of
InstrumentTag.
Warning PI point <%s> is refused because of the invalid attribute of
Location [4].
Warning The value quality of PI point <%s (PointID: %d)> with FactoryTalk
Live Data item <%s> is bad.