Rockwell Automation FactoryTalk Historian SE 4.0 Live Data Interface User Guide - Manual (Page 52)

Chapter 12 Error and Informational Messages
52 Rockwell Automation Publication HSELD-UM024A-EN-E–September 2013
Severity Message text
Warning Failed to convert PIEvent to FTLD variant type of data.
Warning Failed to write value to FactoryTalk Live Data item <%s>.
Warning Monitor disconnected from FactoryTalk service.
Warning Monitor reconnected to FactoryTalk service successfully.
Warning The value quality of PI point <%s (PointID: %d)> with FactoryTalk
Live Data item <%s> is bad because the FTLD service does not
respond in %d ms.
Information PI point <%s> has been removed from the FTLD interface
(InterfaceID: %d).
Information PI point <%s> is edited in the FTLD interface (InterfaceID: %d).
Information PI point <%s> has been added to the FTLD interface (InterfaceID:
%d).
Information Connected to FactoryTalk Directory scope %s successfully.
Information FTLD interface(ID:%d) has Scan Class %d = %s.
Information Disconnected from FactoryTalk Directory %s successfully.
System errors are associated with positive error numbers. Errors
related to PI are associated with negative error numbers.
The descriptions of system and PI errors can be obtained with the
pidiag utility. It is a command-line utility (pidiag.exe) located in the
C:\Program Files\Rockwell Software\FactoryTalk
Historian\Server\PI\Adm directory.
The following is the syntax to retrieve error descriptions of the
messages:
\PI\adm\pidiag -e error_num
System Errors and PI Errors
Error Descriptions