Rockwell Automation TLY-Series Servo Motor - Manual (Page 10)

10 TL-Series Servo Motors
Publication TL-IN003A-EN-P — June 2007
Installing the Motor
Follow these procedures and recommendations to install a TL-Series motor.
1. Allow sufficient clearances in the area of the motor for it to stay within its specified operating
temperature range.
• Obtain the specified motor thermal rating by mounting the motor on a surface with heat
dissipation equivalent to an aluminum heatsink of the following dimensions.
• Refer to Specifications on page 22 for the operating range.
• Do not install the motor in an area with restricted airflow, and keep other heat producing
devices away from the motor.
ATTENTION
Servo motors are not for direct connection to an ac power line.
Servo motors are designed for connection to a servo drive that controls the application
of ac power.
Failure to observe these safety procedures could result in damage to the motor and
equipment.
ATTENTION
Do not strike the shaft, couplings, or pulleys with tools during installation or removal.
Damage may occur to the motor bearings and the feedback device if sharp impact to the
shaft is applied during installation of couplings and pulleys.
Failure to observe these safety procedures could result in damage to the motor and its
components.
Motor Frame Size Heatsink Dimensions (H x W x D) Approx.
(1)
(1)
Ambient temperature of the specified heatsink is 40 °C (104 °F).
millimeters (inches)
TLY-A1xx 203.0 x 203.0 x 6.4 (8 x 8 x 0.25)
TLY-A2xx 254.0 x 254.0 x 6.4 (10 x 10 x 0.25)
TLY-A25xx, TLY-3xx 305.0 x 305.0 x 12.7 (12 x 12 x 0.5)