Rockwell Automation TLY-Series Servo Motor - Manual (Page 23)

TL-Series Servo Motors 23
Publication TL-IN003A-EN-P — June 2007
Accessories
Accessories available from the factory include the following items.
Motor Cables
Factory manufactured feedback and power cables are available in standard cable lengths. Transition
cables are available to allow connection of servo motors with TLY catalog numbers to existing
N-Series power, feedback, and brake cables. Factory cables provide proper shield termination, which
reduces the potential for EMI.
For a complete listing of available cables refer to your drive’s installation manual, contact your nearest
Rockwell Automation sales office, or access the information from the website references in
Additional Resources on page 24.
Connector Kits
Each connector kit includes the appropriate connector housing, pins, and backshell.
Shaft Seal Kits
Catalog numbers and dimensions for shaft seals are shown below.
Transition Cables
Transition cables interface between N-Series motor cables and the cables on servo motors with TLY
catalog numbers with incremental encoders. The cables are 500 mm (20.0 in.)in length.
Connector Kit Catalog Number Connector Kit Catalog Number
Feedback Connector 2090-KFBM6-00AA Power Connector 2090-KPBM6-16AA
Motor Catalog
Number
(1)
(1)
Shaft seals require a lubricant to reduce wear. Lubricant is provided with kit.
Inside Diameter Outside Diameter Width
mm (in.) mm (in.) mm (in.)
TLY-A110, TLY-A120, TLY-A130 TL-SSN-1 8.9 (0.35) 16 (0.71) 3 (0.12)
TLY-A220, TLY-A230 TL-SSN-2 14.0 (0.55) 24 (0.95) 5 (0.20)
TLY-A2530, TLY-A2540, TLY-A310 TL-SSN-3 19.8 (0.78) 30 (1.18) 5 (0.20)
Feedback Cable
Catalog Number
Power and Brake Cable
Catalog Number
Power Only Cable
Catalog Number
2090-CFBM6CN-04AA 2090-CPBM6CN-16AA 2090-CPWM6CN-16AA