Rockwell Automation 20D PowerFlex 700H/S Frame 14 Replacement Power Structures - Manual

Installation Instructions
PowerFlex
®
700S and 700H Frame 14
Replacement Power Structures
Introduction Important: The Power Modules on PowerFlex 700S Phase II and 700H
frame 14 drives are matched at the factory and cannot be paired
with any other Power Modules. Therefore, when a Power
Module fails, you must replace both power structures on a
frame 14 drive.
Use this document to install replacement power structures on a frame 14
drive. This document covers the following replacement power structures:
What You Need to Do ❐ Step 1: Remove power from the drive
❐ Step 2: Remove the old power structures
❐ Step 3: Install the new power structures
❐ Step 4: Connect the new power structures to the components in the
drive
❐ Step 5: Install the product identification label on the new power
structures
❐ Step 6: Start the drive
Voltage Class
Spare Module Catalog
String
PowerFlex
700H AC
Input PowerFlex
700H DC
Input PowerFlex
700S AC
Input PowerFlex
700S DC
Input
400/480V AC
(540/650V DC) SK-H1-PWRMOD-D1K7 20CC1K7 20CH1K7 na na
20CD1K7 20CJ1K7 na na
SK-H1-PWRMOD-D2K1 20CC2K1 20CH2K1 na na
20CD2K1 20CJ2K1 na na
SK-H1-PWRMOD-D2K7 20CC2K7 20CH2K7 na na
20CD2K7 20CJ2K7 na na
600/690V AC
(810/932V DC) SK-H1-PWRMOD-E1K5 20CE1K5 20CK1K5 20DE1K5 20DK1K5
20CF1K5 20CM1K5 20DF1K5 20DM1K5
SK-H1-PWRMOD-E1K9 20CE1K9 20CK1K9 na na
20CF1K9 20CM1K9 na na
SK-H1-PWRMOD-E2K2 20CE2K2 20CK2K2 na na
20CF2K2 20CM2K2 na na