Rockwell Automation 20D PowerFlex 700H/S Frame 14 Replacement Power Structures - Manual (Page 5)

PowerFlex® 700S and 700H Frame 14 Replacement Power Structures 5
Important: Mark all connections and wires before removal to avoid
incorrect wiring during assembly.
5. Remove the motor connections from the output power terminals on both
of the power structures. Note: The terminals are located in different
positions, depending on whether du/dt filters are installed or not.
6. Remove the ground connections from the bottom of the power structure
enclosures.
7. Remove the input connections from the incoming DC bus terminals at
the top of both power structures.
U/T1 V/T2 W/T3
Side View
U/T1 V/T2 W/T3
ASIC Board Assembly
Power Supply Voltage
Feedback Board Assembly
Ground Terminals
DC Bus Terminals
Output Power Terminals
without du/dt Filters
Output Power Terminals
with du/dt Filters
DC–
(Front Terminals)
DC+
(Back Terminals)